![]() Installing fancontrol sudo apt-get install fancontrol lm-sensors Using the service fancontrol the speed of the fan can be linked to any sensor and any threshold and controlled automatically. ![]() In the BIOS I could set the speed, but the automatic mode did not work properly. Be aware of that the fans stop around under 100 depending on your fan.After I installed a fan in my NAS, it always ran at top speed. If so you can control your fans by setting the PWM type to manual and setting a PWM value from 0-255. Hopefully your fans now show up in sensors. GRUB_CMDLINE_LINUX=‘acpi_enforce_resources=lax’ Make sure the instruction acpi_enforce_resources=lax is set in your grub configuration (/etc/default/grub). Google your chip id and there is a good chance to find what kernel module you have to load.Įxecute modprobe nct6775 to load the kernel moduleĪdd the line nct6775 to the file /etc/modules-load.d/nf In my case a Super I/O chip of the type VIA/Winbond/Nuvoton/Fintek found.īut sensors-detect fails with “unknown chip with ID 0xd42b” Trying family `VIA/Winbond/Nuvoton/Fintek'. (logical device B has address 0x290, could be sensors) ![]() Trying family `National Semiconductor/ITE'. This is usually safe.ĭo you want to scan for Super I/O sensors? (YES/no): Be careful and abort with CTRL+C after seeing the following output.Įxecute sensors-detect and follow the instructions until you see this: Some Super I/O chips contain embedded sensors. The following command can damage your system! The chance is low but it can happen. If you can’t see the fan states in sensors you have to detect them first and load a kernel module that fits to your chip. First you have to make sure your fans show up in “sensors”
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |